Oxford Handlebar Muffs (OX557)

The Oxford Handlebar Muffs are packed with features...

Specifications include:

• Warm, waterproof and windproof for total hand protection
• Special 3D design for efficient and non-snag operation of control levers
• Pre-formed opening for easy access
• 1500 Denier polyester fabric for durability
• Reflective piping for increased visibility to other road users
• Universal design that fits the majority of motorcycles
• Includes internal pocket for fitment of heat pouches or Oxford HotHands to create heated muffs

The contents include:

• 1 Left and 1 right Muff, each Muff should be installed so that the writing is visible and facing upwards when fitted
• 2 PVC washers. These should be used to seal the "hole" that will need to be made in the upper panel of the Muff to accommodate the mirror stem when necessary

Fitting guidelines:

• If the motorcycle has handlebar mounted mirrors, they should be removed before fitting the Muffs
• Each Muff should then be pulled over the handlebar as far as is possible, the brake/clutch reservoir should be accommodated by the gap inside the Muff itself and in some situations it might be necessary to pull the Muff further inwards and over the brake/clutch reservoir to ensure that the thumb control can be reached without hindrance. Remember to fasten the popper!
• Then fit the strap through the buckle and then tighten around the handlebar.
• If you have removed the handlebar mounted mirrors, then take a sharp knife and pierce the material of the upper side of the Muff in the shape of a cross exactly where the mirror stem will come through the Muff to tighten it down.
• On the mirror stem, screw the PVC washer onto the thread so that when this is tightened down to the Muff material it will create a watertight seal and cover the newly formed cut hole.
• Finally, to keep the muffs in position, join them with the interconnecting strap.
• It is important to ensure that the fitted Muffs do not interfere with the rider controls and that sufficient clearance is maintained at all times. Pay particular attention to ensure that the thumb controls and cut-off switch are not too close to the inward facing section of the Muff. If the controls cannot be operated easily or rub against the fabric of the Muff then either re-position the Muff or remove from the motorcycle and do not use

How to create Heated Oxford Muffs

The new and unique design has two special mesh pockets built inside the top panel. This means that the Oxford HotHands product can be positioned inside the Muffs and when connected to the handlebar mounted switch and wiring loom will create a heated panel above your hands and fingers to keep them in the coldest of weathers.
Inside the mesh pockets you will find section of Velcro which attach to those on the HotHands in order to secure it in the right position. The power cable to the HotHands is fed through a special channel in the Muff and exits onto the handlebar and then joins the switch and wiring loom. The fitment on the HotHands is designed not to interfere with any of the motorcycle control gear.

Internal pocket for Oxford Hothands to create heated muffs (optional)

PLEASE NOTE: Oxford Muffs are designed for use at UK road legal speeds

Your package will include the following:

• Oxford Handlebar Muffs (OX557)
• 1 x Left Muff
• 1 x Right Muff
• 2 x PVC Washers
• Full Fitting Instructions